Pairing Instructions
- Turn power off to receiver by turning ignition key off
- Install the yellow “pairing” jumper into the wireless remote receiver harness end, found in lower cab box
- With transmitter turned off, simultaneously press chute up and chute lock transmitter and receiver indicator will light up to designate safe pairing
- Turn ignition key to accessory position (Step 4 must be done within 10 seconds of Step 3)
- The transmitter will confirm the download is complete by flashing LED #3 (top left) eight times
- The receiver LED display will flash PO-ID
- Turn ignition key off. Remove the yellow “pairing” jumper and screw dust cap on the harness end
- Start engine and test
Driver Adjustable Parameters
- Press "Menu"
- Press "Adjust"
- Enter default password "2006"
- Press "Mixer Adjustments"
- Select "Latch MPH" (speed at which constant speed will turn on) range from 15 - 25 mph
- Select "Conspeed" (speed at which drum will rotate when constant speed is activated) range from 1 - 3 rpm
- Select "ON-OFF" for beacons to activate automatically when reverse gear is selected
- Select "ON-OFF" for work lights to activate automatically when reverse gear is selected
- The "G11 Accessory" is only to be turned ON when in remote programming mode